wireshark display filter for source address

Wireshark 4.0 adds the following: ip.addr any_eq 10.100.100.1 In Wireshark 3.6 and later, if none of these match, we have a winner. In Wireshark 3.4 and earlier, if any of these don’t match, we have a winner. Wireshark also has “!=” (not equal), which was a bit confusing in past versions. You have been able to do the following comparison operators since Wireshark’s inception: ip.addr = 10.100.100.1 Will match the inner address, and ip.src = 10.1.2.3Īlong with layers, you can be much more specific about matching zero, one or more, or all fields in a particular packet. Will match the outer address, ip.src#2 = 10.1.2.3

For example, if we have a GRE packet with both outer and inner IPv4 layers, ip.src#1 = 10.1.2.3 To use the layer operator, just put a number sign and a layer number after a field. In order to reduce this ambiguity Wireshark 4.0 adds a layer operator, which lets you select a specific occurrence of a field. It’s convenient, but it also means you’re guaranteed to have two “ip.addr” fields for each IPv4 header which means guaranteed ambiguity. Even worse, Wireshark has a completely made up “ip.addr” field, which is an alias for both “ip.src” and “ip.dst”. In any case a filter like “ip.src = 10.1.2.3” can be ambiguous. Maybe you live on the edge and used scapy to create a packet with a hundred or a thousand layers of IP in IP nesting. You might be in an environment that uses some form of tunneling like GRE or one of the many VPN protocols, and even on simple networks ICMP errors carry the IPv4 header of the offending packet. You might assume that the packets on your network have one IPv4 header and therefore one source address, but that’s not necessarily the case. Within Wireshark that means using the “ip.src” filter field. Suppose you want to filter on an IPv4 source address. These improvements give you more control over the way that multiple occurrences of the same field are handled, let you do arithmetic, and many other things.įirst, let’s look at the way multiple field occurrences are handled.

Display Filter Changesĭisplay filters are one of Wireshark’s defining features and 4.0 makes them more powerful and more consistent. I’ll cover some highlights here, but the release notes go into much greater detail. If you are a regular Wireshark user we recommend that you pay close attention to the release notes this time around, since it includes quite a few changes. Wireshark 4.0 was released today, and as you might have guessed from the version number, quite a few things have changed since 3.6.

Wireshark display filter for source address